Jul 1, 2022 · I wanted a valve on the main line and a plumber installed a shark bite valve Now, 6 years later, I find that the fitting is spinning. It might have been spinning earlier as well and I …

Nov 20, 2013 · A 1/2" Sharkbite needs about an inch of pipe to seat fully if I remember (it says on the package and varies by the diameter of the fitting). A compression fitting also needs a …

An error occurred while the page was being generated. Please try again later.

Mar 31, 2013 · What do you suppose the grease/lube in the Sharkbite fittings is for. To keep the O Ring from Drying out . I never realized there was grease...

Feb 28, 2025 · 1. Is it okay to use a sharkbite immediately off the incoming line before the main shutoff like I am planning, or should this always be soldered? 2. If the answer to 1 is soldered, …

Nov 20, 2008 · I've got a couple shark bite caps on hot and cold water copper supply lines that I'm ready to remove and replace with valves (plumber put them on). I thought it would be a simple …

May 30, 2020 · On another thread, a pro maintenance plumber says he always uses Sharkbite for repairs and they'll last as long as copper fitting repairs. While I'm old school enough to wonder …

Jul 29, 2020 · If there is still solder on the copper will Sharkbite connector still work. I may need to cut the pipe with a dremel or hacksaw then find a way to deburr/smooth the outside edge.

May 26, 2017 · I am considering a sharkbite flex hose 3/4 to connect a water heater. I have seen braided steel and corrugated steel options. What is the difference? I have seen pictures and …

Nov 10, 2009 · In Europe, Sharkbite-like compression fittings have always been the norm. Even thought PEX isn't PB, I have a hunch that its long-term crimped reliability won't be a whole lot …